Table of Contents

X2200 M2 (quad opteron)

LM-Sensors

modprobe ipmi_devintf ipmi_si ipmi_msghandler
ipmitool -I open sdr

Quick Reference

Note - Case Sensitive 

set /SP/AgentInfo DhcpConfigured=disabled
set /SP/AgentInfo IpAddress=xxx.xxx.xxx.xxx
set /SP/AgentInfo Gateway=xxx.xxx.xxx.xxx

set /SP/SystemInfo/CtrlInfo BootCtrl=BIOSSetup
set /SP/SystemInfo/CtrlInfo PowerCtrl=reset
set /SP/SystemInfo/CtrlInfo PowerCtrl=gracefuloff
set /SP/SystemInfo/CtrlInfo PowerCtrl=forceoff
set /SP/SystemInfo/CtrlInfo PowerCtrl=on
set /SP/AgentInfo/console/speed=115200
start /SP/AgentInfo/console

To revert to CLI once the console has been started, press Esc-Shift-9 Esc ( keys.

Note - After running the start command, no output will be displayed until the server is rebooted.

Detailni navod jak na iLOM

Co je treba udelat na strane debiana/ubuntu:

  1. vyradit parametry kernelu quiet a splash
  2. pridat parametry console=tty0 console=ttyS1,115200n8
  3. spustit getty na portu ttyS1 (pro fanousky solarisu – ttyb)

Na Debianu pridat do /etc/inittab radku T0:23:respawn:/sbin/getty -L ttyS1 115200 vt100 Na Ubuntu pridat do /etc/event.d/ttyS1 cely soubor 

# ttyS1 - getty
#
# This service maintains a getty on ttyS0 from the point the system is
# started until it is shut down again.

start on runlevel 2
start on runlevel 3
start on runlevel 4
start on runlevel 5

stop on runlevel 0
stop on runlevel 1
stop on runlevel 6

respawn
exec /sbin/getty 115200 ttyS1

Na konzoli se prihlasime pres ssh na standardnim portu 22. Napiseme prikaz start /SP/AgentInfo/console a meli bysme obdrzet vystup podobny: 

Ubuntu 8.04 archiv ttyS1

archiv login:

Pokud vam spadne pripojeni, konzole zustane aktivni. Bud se vam povede relogin, nebo ji muzete vypnout stop /SP/AgentInfo/console a znovu nahodit.