hardware:firewall [Starlab knowledge base]

[Show page]
[Old revisions]
[[unknown link type]]
[
]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Nase red-box krabicky ======
**Note:** default baud rate 38400

** Vypis po bootu: **
<code>
*** baud: 38400 ***
PC Engines ALIX.2 v0.98
640 KB Base Memory
261120 KB Extended Memory

01F0 Master 044A CF CARD 1GB                             
Phys C/H/S 1934/16/63 Log C/H/S 967/32/63
PC Engines ALIX.2 v0.98
640 KB Base Memory
261120 KB Extended Memory

01F0 - no drive found ! 
No boot device available, press Enter to continue.
</code>

**Bios**
<code>
Setup options
To enter setup, type S during the memory test. You should see something like the following:
PC Engines ALIX.2 v0.98j
640 KB Base Memory
261120 KB Extended Memory
01F0 Master 848A CF 128MB
Phys C/H/S 1002/8/32 Log C/H/S 1002/8/32
BIOS setup:
(9)  9600 baud (2) 19200 baud *3* 38400 baud (5) 57600 baud (1) 115200 baud
*C*  CHS mode (L) LBA mode (W) HDD wait (V) HDD slave (U) UDMA enable
(M)  MFGPT workaround
(P)  late PCI init
*R*  Serial console enable
(E)  PXE boot enable
(X)  Xmodem upload
(Q)  Quit
</code>

====== Installation =======
Hi,

I've also installed debian on the alix board. I did it this way:

1. setup DHCPD with this option:
    subnet 192.168.1.0 netmask 255.255.255.0 {
        option routers 192.168.1.1;
        range 192.168.1.10 192.168.1.20;
        filename "debian-installer/pxelinux.0";
        next-server 192.168.1.100;
  }

2. setup TFTP server, I like tftpd-hpa. Here is /etc/default/tftpd-hpa
     TFTP_USERNAME="tftp"
     TFTP_DIRECTORY="/srv/tftp"
     TFTP_ADDRESS="0.0.0.0:69"
     TFTP_OPTIONS="--verbosity 65535 --create --secure"

3. download debian's net-install - netboot.tar.gz
    mkdir -p /srv/tftp
    cd /srv/tftp
    tar xzf netboot.tar.gz

4. add first line debian-installer/i386/boot-screens/syslinux.cfg
    SERIAL 0 9600 0

5. change debian-installer/i386/boot-screens/txt.cfg
    append console=ttyS0,9600n8 initrd=debian-installer/i386/initrd.gz --


And now you can run normal Debian's install ;-)
====== Files ======
  * {{:hardware:alix2.pdf|}}

hardware/firewall.txt · Last modified: 2011/02/14 14:08 by 78.102.76.85