- [Show page]
- [Old revisions]
- [[unknown link type]]
- []
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
linux:ilo [2015/11/11 09:22] vondra [Setup LO100] |
linux:ilo [2015/11/11 09:40] (current) vondra [Setup network] |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| ===== Setup LO100 ===== | ===== Setup LO100 ===== | ||
| - | poor man's iLo | + | LO100 is poor man's iLo that can be found in HP DL1xx - it is derived from IBM BCM |
| + | |||
| + | following commands should work on all machines equipped either with LO100 or iLO 3 and higher (maybe other management consoles - e.g. Dell, IBM, Sun) | ||
| ==== Install ipmitool ==== | ==== Install ipmitool ==== | ||
| the ipmitool utility allows you to change iLo settings without rebooting the server | the ipmitool utility allows you to change iLo settings without rebooting the server | ||
| Line 47: | Line 49: | ||
| </code> | </code> | ||
| + | ==== Setup network ==== | ||
| + | - find out the lan channel<code bash> | ||
| + | for i in `seq 1 14`; do ipmitool lan print $i 2>/dev/null | grep -q ^Set && echo Channel $i; done</code>let the output be <code bash>Channel 2</code> | ||
| + | - show network configuration<code bash> | ||
| + | ipmitool lan print 2</code> | ||
| + | - setup static ip adress<code> | ||
| + | ipmitool lan set 2 ipsrc static | ||
| + | ipmitool lan set 2 ipaddr 10.0.255.x | ||
| + | ipmitool lan set 2 netmask 255.255.255.0 | ||
| + | ipmitool lan set 2 defgw ipaddr 10.0.255.1</code> | ||
| + | - do a cold reset<code bash> | ||
| + | ipmitool mc reset cold</code> if it doesn't take effect you can try connect to iLo via ssh and run<code>reset map1</code> | ||
linux/ilo.1447230142.txt.gz · Last modified: 2015/11/11 09:22 by vondra