iLo

Pro ssh pristup je nutne pouzit parametry:

ssh -o ForwardAgent=no -o ForwardX11=no -o HostKeyAlgorithms=ssh-rsa,ssh-dss user@ip

Pro novejsi OpenSSH je treba pouzit nasledujici alias:

alias ilossh='ssh -o PasswordAuthentication=yes \
-o ChallengeResponseAuthentication=no \
-o GSSAPIAuthentication=no \
-o HostbasedAuthentication=no \
-o PubkeyAuthentication=no \
-o RSAAuthentication=no \
-o Compression=no \
-o ForwardAgent=no \
-o ForwardX11=no \
-o KexAlgorithms=diffie-hellman-group1-sha1 \
-o MACs=hmac-md5,hmac-sha1 \
-o Ciphers=aes128-cbc,3des-cbc \
-o HostKeyAlgorithms=ssh-rsa,ssh-dss'

LO100 is poor man's iLo that can be found in HP DL1xx - it is derived from IBM BCM

following commands should work on all machines equipped either with LO100 or iLO 3 and higher (maybe other management consoles - e.g. Dell, IBM, Sun)

the ipmitool utility allows you to change iLo settings without rebooting the server

1. install the package

   apt-get install ipmitool

2. the service job usually fails to run so you have to load following kernel modules in order to use ipmitool

   modprobe ipmi_msghandler
   modprobe ipmi_devintf
   modprobe ipmi_si

3. try to start the service again

   service ipmievd start

1. list users:

   ipmitool user list

2. change password for desired user - in this case user no 3

   ipmitool user set password 3 my-password
   ipmitool user enable 3

3. set this user as administrator

   ipmitool user priv 3 4

1. find out the lan channel

   for i in `seq 1 14`; do ipmitool lan print $i 2>/dev/null | grep -q ^Set && echo Channel $i; done

   let the output be

   Channel 2

2. show network configuration

   ipmitool lan print 2

3. setup static ip adress

   ipmitool lan set 2 ipsrc static
   ipmitool lan set 2 ipaddr 10.0.255.x
   ipmitool lan set 2 netmask 255.255.255.0
   ipmitool lan set 2 defgw ipaddr 10.0.255.1

4. do a cold reset

   ipmitool mc reset cold

   if it doesn't take effect you can try connect to iLo via ssh and run

   reset map1